NOTE: The Stop key is also used to reset the treadmill
if an "EI" or programming error should occur
(if "EI" should appear in your LED Matrix window).
Simply pull the Stop key out momentarily and
re-insert it into the Display Console.
BELT & RUNNING SURFACE
Belt Condition
Inspect the Running belt monthly to check it's condition. Look for loose
pieces, tears or extremely worn areas. If these conditions occur, replace
the running belt immediately.
Please call STEELFEX Customer Support to purchase a replacement
running belt.
For XT4600/4800 models only
For XT-3200/3300/3600/5600/5700
models only
SAFE KEY
2
To Next Page
Loading...
