6
POWER SOURCE
This product is designed to operate on 230V 50Hz AC Mains only. Attempting to
operate this system from any other power source may cause damage to the
system, and such damage is not covered by your
warranty.
NOTE: You will note that this system is equipped with a
standard domestic AC power 3-pin plug. If this plug will
not fit into your outlet, you probably have an outdated
non-polarized AC outlet. You should have your outlet
changed by a qualified licensed electrician.
IMPORTANT
If the colours in the
Mains Lead of this
appliance do not
correspond with the
coloured markings
identifying the
terminals in your plug, proceed as follows:
• The wire which is coloured BROWN must be connected to the terminal which
is marked 'L' or coloured RED.
• The wire which is coloured BLUE must be connected to the terminal which is
marked 'N' or coloured BLACK.
DO NOT CONNECT EITHER WIRE TO THE ‘E’ EARTH TERMINAL OF A 3-PIN PLUG
This appliance must be protected by a 3A fuse in a 13A Type (BS1363) plug.
Should you need to replace the fuse, use only a BS1362 fuse.
PROTECT YOUR FURNITURE
This model is equipped with non-skid rubber 'feet' to prevent the product from
moving when you operate the controls. These 'feet' are made from non migrating
rubber material specially formulated to avoid leaving any marks or stains on your
furniture. However certain types of oil based furniture polishes, wood
preservatives, or cleaning sprays may cause the rubber 'feet' to soften, and
leave marks or a rubber residue on the furniture. To prevent any damage to your
furniture we strongly recommend that you purchase small self-adhesive felt
pads, available at hardware stores and home improvement centres everywhere,
and apply these pads to the bottom of the rubber 'feet' before you place the
product on fine wooden furniture.
IMPORTANT: Raising and Lowering the Lid
To open the lid, raise it as far as it will go until the lid support bracket locks in the
open position. To close the lid, lift the lid upward slightly, pull the lid support
bracket slightly forwards, and then gently lower the lid.
TO AVOID DAMAGING THE CABINET OR THE LID, NEVER FORCE THE LID CLOSED.
ALWAYS RAISE THE LID TO RELEASE THE LID SUPPORT BRACKET.
To Next Page
Loading...
