Steinbach Poolrunner Battery Pro - Stopping cleaning; Cleaning

Stopping cleaning
Cleaning stops automacally when the rechargeable baery is almost drained.
The status indicator blinks yellow while the device travels toward the pool wall. Once it is
at the wall, it is lit solid yellow.
Lifting the device out of the pool
NOTICE!
The pump of the device can be damaged if it is switched on or o
outside of the water.
- Only switch the device on or o when it is located below the
water surface.
1. Slowly pull the device to the surface of the water using the hook and a telescopic rod
unl you can reach the handle.
2. Slowly li the device out of the water by the handle and hold it above the water
surface for 10 to 15 seconds so that most of the water can ow back into the pool.
3. Turn o the ON/OFF switch.
The status indicator goes out and the device switches itself o.
4. Set down the device next to the pool.
The device is lied out of the pool.
Clean the device aer each use to ensure connued fault-free operaon.
Cleaning
NOTICE!
Improper cleaning might damage the device.
- Clean the surface of the device with plain water aer each use.
- Do not use any aggressive cleaning agents.
- Do not use any sharp or metal objects such as knives, hard
scrapers or similar.
- Do not use any cleaning brushes.
- Do not use a high-pressure cleaner.
37
en