Steinbach Poolrunner Battery Pro - Page 40

Fault descripon Cause Remedy
The device cannot reach all
spots.
The water circuit of the pool is
switched on.
Switch o the lter system of
the pool.
The device becomes stuck on
the drain grate.
Switch o the lter system of
the pool.
The device does not
completely move up the wall.
The lter is clogged. Clean the lter.
Algae grows on the walls. Clean the pool walls.
The water temperature is too
high or too low.
Operate the device at water
operang temperature (see
secon "Technical data").
The res or the cleaning roller
is/are worn.
Check the res and the
cleaning roller for wear and
replace them if necessary.
The device is too light and
topples.
Switch o the device and let all
the air escape.
The pH value and the chlorine
quanty are not properly set.
Adjust the pH value and the
chlorine value to the correct
value (see secon "Technical
data").
The device has too lile
buoyancy.
Aach addional buoyancy
aids (part of the package
contents). See "Installing the
buoyancy aids".
The device does not sink. There is air in the device. Switch o the device and let all
the air escape.
The salt content is too high
and the device has more
buoyancy.
Set the correct salt content.
See secon "Technical data".
The device rises to the surface. The device climbs too high or
there is air trapped in the
device.
Switch o the device and let all
the air escape.
The salt content is too high
and the device has more
buoyancy.
Set the correct salt content.
See secon "Technical data".
The device is defecve. Contact customer service.
If the problem cannot be solved, contact the customer service listed on the last page.
40