Steinbach Poolrunner Battery+ - Attaching the Brush; Removing the Brush

1. Guide the end of the nylon cord of the
oang handle
6
through the eyelet
on the top part
2
.
2. Shorten the nylon cord to a length that
roughly corresponds to the depth of
your pool and e it in a knot.
The oang handle is aached.
Attaching the brush
1. Press the brush strip
5
into the recess
on the boom of the lower unit
4
.
2. Make sure that the brush strip
5
has
completely engaged and ts ghtly.
The brush is installed.
Removing the brush
1. Unlatch the hook of the brush strip
5
from the inside and press the brush
strip out of the boom part
4
at the
same me.
2. Take out the brush strip
5
.
The brush is taken out.
7
6
2
Only aach the brush if it can assist cleaning (e.g. for removing a biolm). In the case of
an incline, unevenness or too much dirt on the oor, the brush may have an adverse
eect on the cleaning result.
8
4
5
9
4
5
37