Steinbach Poolrunner Battery+ - Device Cleaning and Maintenance; Cleaning Procedure

The status indicator blinks red once and the device switches itself o.
3. Slowly li the device out of the water by the handle and hold it above the water
surface for 10 to 15 seconds so that most of the water can ow back into the pool.
4. Set down the device next to the pool.
The device is lied out of the pool.
Clean the device aer each use to ensure connued fault-free operaon.
Cleaning
NOTICE!
Improper cleaning might damage the device.
- Clean the surface of the device with plain tap water aer each
use.
-
Do not use any aggressive cleaning agents.
- Do not use any sharp or metal objects such as knives, hard
scrapers or similar.
-
Do not use any cleaning brushes.
- Do not use a high-pressure cleaner.
1. Pull the two snap locks apart and li o
the top part
2
.
15
2
4
41