Steinbach Poolrunner Battery+ - Page 43

Fault descripon Cause Remedy
The device cannot reach all
spots.
The nozzle seng is not
suitable.
Change the seng of the
nozzles.
The water circulaon of the
pool is switched on.
Switch o the lter system of
the pool.
The device does not work and
the status indicator blinks blue.
The pump is running dry. Wait unl the device is in the
water before switching it on.
The device does not funcon. There is air in the device. Switch o the device and let all
the air escape.
There are foreign objects in
the drive.
Contact customer service.
The device oats up or turns in
a circle on the boom of the
pool.
Too much air in the housing. Let all air escape.
The salt content is too high
and the device has more
buoyancy.
Set the correct salt content.
See secon "Technical data".
The rechargeable baery
runme is shorter than
expected.
The water circulaon of the
pool is switched on.
Switch o the lter system of
the pool.
The water temperature is too
low.
Only use the device under the
permissible operang
condions. See secon
"Technical data".
The rechargeable baery was
not completely charged.
Charge the rechargeable
baery completely.
The pool oor is not level. Only use the device in pools
with a level oor.
If the problem cannot be solved, contact the customer service listed on the last page.
43