Steinberg UR-RT4 User Manual (English)

Other manuals for Steinberg UR-RT4

Questions and Answers:

T
terrellkathleenJul 28, 2025
Why is there no sound from my Steinberg UR-RT4 Accessories?
- W
  whillJul 28, 2025
  If you're experiencing no sound with your Steinberg Accessories, ensure that the TOOLS for UR-RT has been properly installed. Also, verify that you are using a proper USB cable, replacing it if broken or damaged, and ensuring it's no longer than 3 meters. Check that the volume controls ([OUTPUT] knob and [PHONES] knob) are set to appropriate levels. Confirm that the microphones and monitor speakers are correctly connected to the device. Additionally, ensure that the audio driver settings on your DAW software are properly configured and that the [ASIO Driver] setting on the Cubase series program is correctly selected.
M
Michelle GibsonAug 3, 2025
What to do if there is no sound from Steinberg UR-RT4 Accessories after starting DAW?
- H
  hartjamieAug 3, 2025
  If you encounter a no sound issue after starting your DAW with Steinberg Accessories, make sure that the device was powered on before launching the DAW software. Also, check that the monitor speaker switch is turned on. If the buffer size is set too low, try increasing it.
J
jonesmanuelAug 12, 2025
How to fix unusual sound from Steinberg UR-RT4 Accessories?
- J
  Jay GayAug 12, 2025
  If you are experiencing unusual sound issues such as noise, interruption, or distortion with your Steinberg Accessories, first check if your computer meets the system requirements. If you are recording or playing long continuous sections of audio, reduce the number of audio tracks. Ensure that microphones are properly connected to the device using an XLR plug. Also, verify that the loopback function is properly set; turn it off when not in use.
E
Edward GrahamAug 18, 2025
What to do if my Steinberg UR-RT4 Accessories power does not turn on?
- J
  Jeremy NewtonAug 18, 2025
  If your Steinberg Accessories device isn't powering on, first ensure that the TOOLS for UR-RT has been installed correctly. Next, verify that the AC adapter is properly connected, as the UR-RT is not a bus-powered device. Also, confirm that you are using a suitable USB cable, replacing it if damaged, and ensuring it is no more than 3 meters long.

Steinberg UR-RT4 Specifications

General

Type	Audio Interface
Channels	4
Preamps	2
A/D Resolution	24-bit
Sample Rate	192 kHz
Bit Depth	24-bit
Analog Inputs	4
Analog Outputs	4
MIDI I/O	Yes
Phantom Power	Yes
USB	USB 2.0
Rupert Neve Designs Transformers	Yes
Direct Monitoring	Yes
Compatibility	Windows, macOS