Need help?Do you have a question about the Steinberg UR28M and is the answer not in the manual?
General| Type | Pre-amp |
|---|---|
| Bit rate | 24 bit |
| Proper use | Concert/Studio |
| Sample rate | 96 kHz |
| Product color | Black, Silver |
| Headphone out | Yes |
| Audio (L/R) in | 3 |
| Audio (L/R) out | 1 |
Weight and Dimensions| Depth | 164 mm |
|---|---|
| Width | 291 mm |
| Height | 59 mm |
| Weight | 1400 g |
Highlights key functionalities like D-PRE, monitor control, and DSP mixer.
Describes the connectors and controls on the back of the UR28M.
Details the controls and indicators on the front of the UR28M.
Adjusts input signal levels for MIC/LINE/HI-Z.
Describes connections for microphones, guitars, and basses.
Adjusts the output signal level of LINE OUTPUTs.
Turns the device power on and off.
Configures ASIO driver settings like device and buffer size.
Window for configuring the entire signal flow of the DSP mixer.
Area for configuring master channel settings.
Window for configuring common device settings.
Configures general audio driver settings like sample rate and clock source.
Area for configuring input channel settings and effects.
Area for selecting and configuring MIX settings.
Interface for configuring the DSP mixer and effects.
Selects the type of effect to use.
Adjusts the signal level of a channel.
Area for configuring DAW channel settings.
Configures input settings within Cubase series programs.
Configures general device settings within Cubase series programs.
Selects where effects are applied (monitor, recording, or both).
Details the controls for the compressor section.
Details the controls for the equalizer section.
Details the controls for the REV-X effect.
Details controls for the DRIVE amp type.
Details controls for the CLEAN amp type.
Details controls for the LEAD amp type.
Continues step-by-step guide for recording with Cubase.
Basic instructions for operating with Cubasis on iPad.
Continues steps for recording and playback with an iPad.
How to record vocals using built-in effects.
Steps for recording using dspMixFx UR28M with non-Cubase DAWs.
How to use the device as a standalone mixer or A/D-D/A converter.
Illustrates the signal paths within the UR28M device.
Presents comprehensive block diagrams of the UR28M's circuitry.
To Next Page
