Panel Controls for the Software Programs
UR28M Operation Manual 23
1 ATTACK
Adjusts the attack time of the compressor.
Range: 0.092 msec – 80.00 msec
2 RELEASE
Adjusts the release time of the compressor.
Range: 9.3 msec – 999.0 msec
3 RATIO
Adjusts the ratio of the compressor.
Range: 1.00 – ∞
4 KNEE
Selects the knee type of the compressor.
5 SIDE CHAIN Q
Adjusts the band width of the side chain filter
(page 33).
Range: 0.50 – 16.00
6 SIDE CHAIN F
Adjusts the center frequency of the side chain
filter.
Range: 20.0 Hz – 20.0 kHz
7 SIDE CHAIN G
Adjusts the gain of the side chain filter.
Range: -18.0 dB – +18.0 dB
8 COMPRESSOR On/Off
Turns the compressor on (lit) and off (dark).
9 Compressor Curve
This graph indicates the approximate compressor
response. The vertical axis indicates the output
signal level, and the horizontal axis indicates the
input signal level.
) Gain Reduction Meter
Indicates the gain reduction.
! DRIVE
Adjusts the degree to which the compressor is
applied. The higher the value, the greater the
effect.
Range: 0.00 – 10.00
Equalizer
1 Equalizer Curve
This graph indicates the characteristics of the 3-
band equalizer. The vertical axis indicates the
gain, and the horizontal axis indicates the
frequency. You can adjust LOW, MID, and HIGH
by dragging each handle in the graph.
2 LOW F
Adjusts the center frequency of the low band.
Range: 20.0 Hz – 1.00 kHz
3 LOW G
Adjusts the gain of the low band.
Range: -18.0 dB – +18.0 dB
4 MID Q
Adjusts the band width of the middle band.
Range: 0.50 – 16.00
5 MID F
Adjusts the center frequency of the middle band.
Range: 20.0 Hz – 20.0 kHz
6 MID G
Adjusts the gain of the middle band.
Range: -18.0 dB – +18.0 dB
7 HIGH F
Adjusts the center frequency of the high band.
Range: 500.0 Hz – 20.0 kHz
8 HIGH G
Adjusts the gain of the high band.
Range: -18.0 dB – +18.0 dB
9 EQUALIZER On/Off
Turns the equalizer on (lit) and off (dark).
Option Description
SOFT Produces the most gradual change.
MEDIUM Middle setting between SOFT and
HARD.
HARD Produces the sharpest change.
To Next Page
Loading...
