Steinberg UR28M - Input Settings Window; MORPH; Effect Insertion Location; REV-X Edit

Panel Controls for the Software Programs
UR28M Operation Manual 19
Panel Controls
Input Settings Window
1 +48V
Indicates the on/off status of the phantom power
function of the device.
2 Phase
Turns on (lit) and off (dark) the phase inversion of
the signal.
3 High Pass Filter
Turns on (lit) and off (dark) the high pass filter.
To select the cutoff frequency of the high pass
filter, use the “Settings Window” (page 21) in the
section “Dedicated Windows for Cubase Series.”
4 Effect Edit
Opens the selected effect setup window.
5 Effect Type
Selects the effect.The maximum number of
Channel Strip and Guitar Amp Classics iterations
which can be used simultaneously has
restrictions. Refer to the “Limitations on the use of
effects” (page 36).
6 DRIVE / Output Level
When Channel Strip is selected, this adjusts the
degree to which the compressor is applied. The
higher the value, the greater the effect.
Range: 0.00 – 10.00
When Guitar Amp Classics is selected, this
adjusts the output level.
Range: 0.00 - 1.00
7 MORPH
Adjusts the Channel Strip Sweet Spot Data.
(Refer to the “MORPH” in the section “Channel
Strip” on page 22.)
When Guitar Amp Classics is selected, MORPH is
not displayed.
8 Effect Insertion Location
Selects the insertion location of an effect.
9 Output Position of the Direct Monitoring
Signal
Indicates the position from which the audio
signals for monitoring will be output when turning
on Direct Monitoring in the device settings on
Cubase.
) REV-X Edit
Opens the “REV-X” (page 24) setup window.
! REV-X Send
Adjusts the signal level which is sent to the
REV-X.
Range: -∞ dB – +6.00 dB
@ Headphones Edit
Opens the “Headphones Window” (page 20) in
the section “Dedicated Windows for Cubase
Series.”
# Reverb Routing Edit
Opens the “Reverb Routing Window” (page 20) in
the section “Dedicated Windows for Cubase
Series.”
Insertion
location
Description
Upper
(OFF)
Turns the effect off.
Middle
(MON.FX)
Applies an effect Strip to only the
monitor signal (sent to the device).
Lower
(INS.FX)
Applies an effect Strip to both the
monitor signal (sent to the device)
and the recording signal (sent to the
DAW software).