32
650/800/850 GUEPARD
SHOCK INSULATORS ADJUSTMENT
Front and rear shock insulators adjustment
It is possible to adjust the spring preliminary
compression to the driver weight and the road
conditions.
Adjust the spring preliminary compression value as
follows. To increase the preliminary load, ease the
locknut with a special wrench, turn the adjustment
nut clockwise, and tighten the locknut. This will make
the suspension more rigid. To reduce the preliminary
load, ease the locknut with a special wrench, turn
the adjustment nut counter-clockwise, and tighten
the locknut. This will make the suspension less rigid.
1. Spring stiffness adjustment nut.
2. Locknut.
NOTE:___________________________________
A special wrench is required for adjustment which
may be ordered from the vendor.
¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯
_________________________
The specifications of shock insulators installed
on different vehicle category T3b sides, should
be similar. Misadjustment may cause the
control restriction and lower stability, which
may cause an accident.
¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯
manufacture website : stelsoffroad.com
To Next Page
Loading...
