44
650/800/850 GUEPARD
ENGINE RUNNING-IN
NOTE: _________________________________
Make sure that the transmission gear lever is
secured in the selected position.
¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯
From Neutral to Reverse, from Reverse to
Parking
1. Bring the vehicle to a full stop.
2. Push the brake pedal. Holding the pedal, select
the Reverse gear (R) using the transmission
gear lever, then the Parking mode (Р).
3. When moving backwards check if there people
or obstacles behind you, and then release the
brake pedal.
4. Open smoothly the throttle and check regularly
the surroundings while reversing.
_________________________________
Failure to observe these conditions may cause
an accident or a run-over of a person behind the
vehicle category T3b.
When shifting to reverse gear make sure that there
are no people or obstacles behind you.
Move at minimum speed.
¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯
Engine running-in
The first 20 operating hours are the most important
of all the engine service life. For that reason you
should read carefully the following information.
As the engine is new, do not overload it during the
first 20 operating hours. Various engine parts are
running- in to the correct operating gaps between
them.
During this period avoid the engine long-term operation
with the throttle fully open or under other conditions
which may cause the engine overheating.
To run-in the engine:
1. Fill the fuel tank with petrol.
2. Check the engine oil level.
3. Move slowly from the start. Choose an open space
so that nothing bars you from familiarizing yourself
with the vehicle control.
4. Change the throttle position. Do not operate it at
idle for a long time.
5. Monitor the fuel level, check regularly the control
elements indicated in the control list and the
segments which should be inspected before
every trip.
manufacture website : stelsoffroad.com
To Next Page
Loading...
