and refill if necessary.
Run engine at idle with the radiator cap
off. Slowly add coolant if necessary.
As this point, wait until engine reaches
normal operating temperature. Depress
the throttle level two or three times;
then add coolant if required.
Install radiator cap. Inspect all
connections for leaks and check
coolant level in the reservoir.
Air Filter
Removal
CAUTION: never remove or modify any
component in the air filter housing.
Otherwise, engine performance
degradation or damage can occur. The
engine is calibrated to operate
specifically with these components.
Remove access panel.
Loosen clamp and remove air filter.
1. Clamp
2. Air filter
Cleaning
Pour cleaning solution or an equivalent
into a bucket. Put the filter in to soak.
While filter soaks, clean inside the air
filter housing.
Rinse the filter with warm water until all
cleaning solution disappears.
Then, let the filter dry completely.
Installation
Properly reinstall removed parts in the
To Next Page
Loading...
