1. Oil filter
2. O-ring
3. Oil filter cover
Screw oil filter cover in place.
Wipe out any oil spillage on engine.
Change gasket on oil drain plug. Clean
gasket area on engine and oil drain
plug then reinstall plug. Refill engine at
proper level with the recommended oil.
Refer to SPECIFICATIONS for
capacity.
Start engine and let idle for a few
minutes. Ensure oil filter area and oil
drain plug areas are not leaking.
Stop engine. Wait a while to allow oi
l to flow down to crankcase then ch
eck oil level. Refill as necessary.
Dispose of oil as per your local
environmental regulations.
Engine Coolant
Recommended coolant
Always use ethylene-glycol antifreeze
containing corrosion inhibitors
specifically for internal combustion
aluminum engine.
Cooling system must be filled with
premixed coolant .
Coolant level
To Next Page
Loading...
