EasyManua.ls Logo

Stels UTV800 - Warming up

Default Icon
139 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 74 -
! WARNING
Do nor connect the negative lead
of the jumper cable to the negative
terminal of the battery in the
vehicle.
Be especially careful not to:
touch the positive lead of the
jumper cable to the negative lead.
reverse the polarity of the jumper
cables when connecting to the
batteries-battery explosion and/or
serious damage to the electrical
system may occur.
6. Start the engine.
7. After the engine starts, disconnect the
negative lead of the jumper cable
from the vehicle and charged battery,
and then disconnect the positive lead
of the jumper cable from the charged
battery and the battery in the vehicle.
8.Install the battery compartment cover.
9. Close the hood.
Warming up
To get maximum engine life, always
warm up the engine before starting off.
Never accelerate hard with a cold
engine! To see whether or not the
engine is warm, check if it responds to
the throttle normally with the starter
(choke) turned off.

Table of Contents

Related product manuals