Break-in
The first month is most important in the
life of your vehicle. Proper operation
during this break-in period will help
assure maximum life and performance
from your new vehicle. The following
guidelines explain proper break-in
procedures.
1、After the engine starts, the engine is
not allowed in high speed in the
neutral gearshift.
2、Drive vehicle from stop to low speed
slowly.
3、 Avoid braking strongly.
4、Do not exceed the vehicle speed on
the below schedule.
Starting and Operating Instructions
● Before starting the engine, be sure
that the driver is seated properly in the
UTV800 and tighten the seat belts.
● Testing the UTV800 in an open place
at the beginning to learn how to start,
turn and stop.
● Operate the UTV800 slowly until you
are familiar with it.
● The turning radius of this UTV800 is
small and agile, so the centrifugal force
is very high when turning at high speed.
Slow down to a more controllable
speed when turning to prevent the
UTV800 from rolling over.
● To prevent vehicle from rolling over,
be sure to only turn the vehicle at a
slow more controllable speed.
To Next Page
Loading...
