Stephan EVE - Preparation for Use; Connecting the Oxygen Cylinder

To connect the oxygen cylinder:
• Fit the oxygen cylinder to the bracket on the
mobile stand and secure.
• Connect the pressure regulator
• Connect the O
2
hose to the O
2
input on the left
side of the EVE.
• Slowly open the valve and then slowly
release it completely.
Note safety instructions
Changing the oxygen cylinder
• Hand-tighten the valve on the gas cylinder
• Drain any residual gas from the pressure
regulator via the output until the pressure
gauge on the pressure regulator shows „0“.
• Loosen the O
2
nist screw connector from
the O
2
input
• Loosen the fastening buckles on the
support frame and carefully remove the
oxygen cylinder
• Remove the pressure regulator from the
valve by turning the screw connector
counter-clockwise and connect to the
new cylinder
• Place the new cylinder in the support
frame and close the fastening buckles
• Fit the O
2
nist screw connector to the
O
2
input
• Open the pressurized gas cylinder‘s valve
Preparation for use