Tech Support: consumer.steppir.com/support | 425.453.1910 | support@steppir.com
22
Section 1.4 (continued): 80m Base Coil Wiring (skip if 80m coil is not pur-
chased)
WIRING
Important Notes:
• Do NOT jumper the radial grounds between the
EHU and coil. The EHU radial ground lug should
be completely disconnected from anything.
• Once the antenna is mounted and your radial set-
up is prepared, the radials can then be attached to
the ground lug on the coil, and coax seal can be
applied to all external electrical connections on the
EHU/coil.
Coil ground lug
To Next Page
Loading...
