FILLING RapidUV™
RESERVOIR
1. REMOVE PURIFICATION PORT
CAP, CLOSE POUR SPOUT
Twist cover gently and pull cap away
from reservoir. Place cap in dry area.
Ensure pour spout is capped.
2. INSERT FITSALL FILTER &
FILTER CARTRIDGE INTO
PURIFYING PORT.
Grab the glow ring and rmly seat FitsAll
Filter into the purication port. Ensure
that Filter Cartridge is properly seated
with air vent open. (This air vent is not
intended for use as a mouth piece)
3. FILL RESERVOIR WITH
FOUR LITERS OF WATER
Pour unpuried water into FitsAll Filter. For
best results place the RapidUV™ Reservoir on
a at surface while adding unpuried water.
Add a maximum volume of no more than 4
liters. RapidUV™ Reservoir will expand to
hold water as you ll it. For convenience a
liter measuring cup is included for lling.
Clean and dry thoroughly after use.
Dry completely before storing.
Fold and store with the cap off.
12 | QUANTUM RAPID PURIFICATION SYSTEM • www.steripen.com
To Next Page
Loading...
