99
19. Steering – Lubricate
20. Check condition and tension of all drive belts.
21. Check all engine mount screws for tight seat.
22. Check for any leaks, deficiencies, signs of wrong use etc.
23. Check function of all warning devices installed.
24. Read out memorized service codes and make necessary corrective actions.
25. Start engine and check for normal instrument display and normal operating noise.
26. Obtain propeller load absorption.
27. Check installation and fill in commissioning report (Installation Manual P/N Z001007-0, chapter 9 Appendix).
28. Grease raw water pump impeller at BUKH-STEYR MOTORS SOLAS engine with original grease of
P/N Z011753/2.
29. Carry out Start-Idle-Test and check engine operation. Check behavior of the boat when engine is in idle gear.
If there are unpleasant vibrations, adjust the engine speed to a vibration-free operation (see Service Manual)
30. Check correct function of gearshift.
31. Stop engine and check again the levels of all operational fluids during test run a certain loss operation fluids
may occur.
(Mechanic’s Signature) (Dealer’s Signature)
DEALER: ......................................................................................................................................................................
ADDRESS AND DATE: ................................................................................................................................................
ENGINE TYPE/SERIAL NUMBER: ..............................................................................................................................
ENGINE RUNNING HOURS: .......................................................................................................................................
SIGNATURE: ................................................................................................................................................................
A copy of the “installation and pre-delivery inspection log” is to be sent to
STEYR MOTORS GmbH, After Sales Service!