STEYR MO256H45 - Commissioning REPORT

100
Engine-serial number: Engine-model:
*) Hybrid-serial number:
Boat Owner:
Company/Name:
Address/Phone:
Dealer:
Company:
Address/Phone:
Type of boat: Dimension of propellers:
Model No.: Special Equipment from STEYR MOTORS
(SCC, IFG, Cabin Heating etc.):
Boat length: m
Boat weight: kg
Driving system: *) Hybrid-Battery specification:
Gear reduction:
Extended Storage Preservation Procedure (acc. SERVICE Manual/GENERAL/D3)
Date of Preservation: # 1 # 2
ENGINE-CHECK POINTS:
Installation checked according to the installation guide. Following points are in compliance:
 1  2  3  4  5  6  7  8  9 10
NOTES:
*) HYBRID
 ELECTRICAL CONNECTIONS according schematic “CONNECTION SCHEMATIC-HYBRID”
(see Hybrid Installation Manual-schematic with art.nr. 2180526-0)
Notes (e.g.: wiring extensions etc.):
 SYSTEM GROUNDS connected (see Hybrid Installation Manual-schematic with art.nr. 2180526-0)
 PROTECTION COVERS mounted on:
 HCU (U, V, W and B+, B–)  Generator (U, V, W)  Hybrid battery (+/–)
 END POSITON / FREE MOVEMENT of Coupling Actuator (D-Mode, E-Mode) ensured
 MAIN SWITCH capacity (between Hybrid battery+ and HCU+): Amp (min. 400 Amp)
 CONSUMERS mounted to Hybrid battery (only to 48 V, max. 100 Amp):
 Hybrid-Cooling:  Raw water cooling  Dual circuit cooling  Keel cooling
COMMISSIONING REPORT