STIEBEL ELTRON DCE-X 10/12 Premium - Operation with Preheated Water

INSTALLATION
Service information
16 | DCE-X Premium www.stiebel-eltron.com
Installing the appliance
D0000073842
321
1 Grommets
2 Flat gasket
3 Strainer with sealed edge
 Mark out the 2holes for drilling with reference to the appli-
ance back panel.
 Fit the grommets in the appliance back panel from the front.
 Drill the holes and secure the appliance using suitable fixing
materials (screws and rawl plugs are not part of the standard
delivery): Countersunk screw, Ø4.5mm, max. diameter of
screw-head 9mm.
Note
 Install the appliance flush to the wall. If necessary,
additionally secure the appliance at the 2 lower at-
tachment points.
 Remove the transport protection plugs from the water con-
nection pipes.
 Secure the DHW connection pipe with a flat gasket and the
cold water inlet line with the sealed-edge strainer (from the
accessories) to the twin connectors.
13.6 Operation with preheated water
You can limit the maximum inlet temperature by installing a cen-
tral thermostatic valve.
14. Service information
Connection overview/ component overview
D0000077189
1
2
3
4
5
6
7
1 Motorised valve
2 Flow meter
3 High limit safety cut-out, automatic reset
4 NTC sensor
5 Pin strips for connected load and anti-scalding protection
6 Programming unit plug-in position
7 Diagnostic traffic lights