To Next PageTo Next Page
Need help?Do you have a question about the STIEBEL ELTRON DCE-C 6/8 Trend and is the answer not in the manual?
General| Power Rating | 6/8 kW |
|---|---|
| Voltage | 230 V |
| Frequency | 50 Hz |
| IP Rating | IP25 |
| Type | Electric instantaneous water heater |
| Flow Rate at ΔT 35 K | 2.5 l/min |
| Temperature Range | 30 - 60 °C |
| Water Connection | 1/2" |
| Rated Current | 26.1 A |
Covers manual structure, safety rules, symbols, and measurement units.
Details safety instructions, symbols, keywords, and the appliance's intended use.
Explains the appliance's operation, heating system, and air detection.
Advises on cleaning methods and scale removal from taps.
Guides on diagnosing and resolving common appliance problems.
Emphasizes that only qualified contractors should perform installation and maintenance.
Highlights the use of original accessories and spare parts for reliable function.
Stresses adherence to national and regional regulations and protection ratings.
Details standard delivery components and optional accessories for the appliance.
Covers site preparation, minimum clearances, and water installation guidelines.
Advises on installing the appliance in a frost-free room near the draw-off point.
Specifies minimum clearances required for trouble-free operation and maintenance.
Provides guidelines for water connection, pipe materials, and flow rate requirements.
Details factory settings for connected load and standard installation on finished walls.
Explains how to open the appliance and prepare the power cable for installation.
Details how to prepare the appliance back panel for cable and connector routing.
Guides on marking holes, drilling, securing the appliance, and fitting taps.
Covers electrical connection safety, power supply, and earthing requirements.
Explains how to change the connected load via the jumper slot and perform initial start-up.
Details repositioning the jumper to select the desired connected load.
Guides on checking the type plate and purging air from the appliance.
Advises on explaining functions, dangers, and handing over instructions to users.
Outlines steps for restarting the appliance after a water supply interruption.
Explains how to isolate power and drain the appliance.
Warns about disconnecting power before work and details electrical connection options.
Guides on breaking out apertures and connecting cables for top entry on unfinished walls.
Details repositioning the mains terminal for bottom entry on unfinished walls.
Explains installing the mains terminal closer to the aperture for short cables.
Covers breaking out apertures and connecting cables for side entry on finished walls.
Details using accessories like grommets, strainers, and pipe bends for water installation.
Advises on limiting maximum inlet temperature with a central thermostatic valve.
Provides an overview of components and connection points for service.
Guides on marking holes, drilling, securing the appliance, and connecting water lines.
Lists diagnostic traffic light signals and provides a table for fault identification and remedies.
Covers draining the appliance and cleaning the strainer, with safety warnings.
Details dimensions, connections, and electrical data for the appliance.
Provides detailed diagrams and specifications for appliance dimensions and connection types.
Shows the electrical wiring diagram for the appliance's components.
Lists DHW output in l/min for various temperatures and connected loads.
Provides data on electrical resistivity and conductivity for application areas.
Details tap pressure drop and pipework sizing recommendations.
Mentions potential fault conditions like high temperatures and pressure.
Presents energy efficiency class, annual consumption, and sound power level.
Summarizes technical data including electrical, application limits, and dimension specifications.
Explains guarantee terms applicable to appliances acquired inside and outside Germany.
Encourages proper disposal of materials according to national regulations.
