To Next PageTo Next Page
Need help?Do you have a question about the STIEBEL ELTRON DCE-S 6/8 Plus and is the answer not in the manual?
General| Type | Instantaneous Water Heater |
|---|---|
| Power Rating | 6/8 kW |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Protection Class | IP25 |
| Water Connection | 1/2 inch |
| Maximum operating pressure | 1 MPa |
Provides critical safety instructions for appliance operation and user safety.
Details additional symbols used in the manual, such as for material losses or disposal.
Specifies the units of measurement used throughout the manual.
Defines the intended domestic and non-domestic uses of the appliance.
Highlights critical safety precautions, including burn risks and supervision requirements.
Refers to test symbols found on the appliance's type plate.
Explains how to select the desired water temperature using the appliance's selector.
Provides recommended settings for energy saving and specific applications.
Emphasizes that only qualified contractors should perform installation and maintenance.
Details safety recommendations for shower operation, especially regarding anti-scalding.
Advises adherence to applicable national and regional regulations and instructions.
Lists the items included in the standard delivery package for the appliance.
Describes optional accessories available for specific installation scenarios.
Specifies requirements for the installation location, including frost protection and vertical mounting.
Explains the steps for standard installation on finished walls, including opening the appliance.
Details how to set internal anti-scalding protection using jumper positions.
Explains how to adjust the appliance's connected load by repositioning a jumper.
Guides through the initial start-up process, including purging air and checking tightness.
Describes electrical connection for appliances on unfinished walls from above.
Details electrical connection for appliances on unfinished walls from below.
Explains how to connect the appliance using a short power cable.
Covers electrical connection for appliances on finished walls from the side.
Provides instructions for water installation on unfinished walls using specific kits.
Offers guidance on operating the appliance with preheated water, e.g., from solar systems.
Illustrates the connection overview and identifies key components of the appliance.
Details the procedure for draining the appliance for maintenance purposes.
Provides detailed dimensions and connection information for the appliance.
Presents the electrical wiring diagram for the appliance.
Details the domestic hot water (DHW) output based on supply voltage and load.
Lists application areas and provides a conversion table for electrical resistivity.
Specifies the tap pressure drop at a given flow rate.
Describes potential fault conditions that may occur briefly during operation.
