INSTALLATION
14 | DCE-S Plus www.stiebel-eltron.com
15.2.1 Cleaning the strainer, standard installation on finished
walls
f Isolate the appliance from the power supply.
f Close the shut-off valve in the cold water inlet line.
f Open all draw-off valves.
f Remove the cold water threaded fitting.
f Remove the strainer from the twin nipple using a flat-blade
screwdriver. Clean the strainer.
f Reinsert the strainer. Screw the cold water connection pipe
onto the twin nipple.
f Open the shut-off valve in the cold water inlet line.
f Vent the appliance and the cold water inlet line (see chapter
"Commissioning/ Initial start-up").
f Switch on the power supply.
15.2.2 Cleaning the strainer, installation on unfinished walls
f Isolate the appliance from the power supply.
f Close the shut-off valve in the cold water inlet line.
f Open all draw-off valves.
f Open the appliance by undoing the screw and lifting up the
appliance cover.
f Unscrew the cold water connection pipe from the twin nip-
ple. Pivot the cold water connection pipe upwards.
f Remove the strainer from the twin nipple. Clean the strainer.
f Screw the cold water connection pipe and the strainer with
sealed edge onto the twin nipple.
f Open the shut-off valve in the cold water inlet line.
f Vent the appliance and the cold water inlet line (see chapter
"Commissioning/ Initial start-up").
f Check the cold water connection for leaks.
f Hook the appliance cover into the appliance back panel at the
top rear. Pivot the appliance cover downwards. Check that
the appliance cover is securely seated both top and bottom.
Secure the appliance cover with the screw.
f Switch on the power supply.
16. Specification
16.1 Dimensions and connections
372
358
343
14
140
175
100
c01c06
35
32
109
b02
D0000073693
DCE-S Plus
b02 Entry for electrical cables I Finished walls
c01 Cold water inlet Male thread G 1/2 A
c06 DHW outlet Male thread G 1/2 A
Alternative connection options
100
c01c06
b02
72
330
b02
b02
69
35
336
b02
b03
30
61
15
b03
D0000073720
DCE-S Plus
b02 Entry for electrical cables I Finished walls
b03 Entry for electrical cables II Unfinished walls
c01 Cold water inlet Male thread G 1/2 A
c06 DHW outlet Male thread G 1/2 A
To Next Page
Loading...
