STIEBEL ELTRON DCE-S 6/8 Plus - Energy Consumption Data; Data Table

INSTALLATION

16 | DCE-S Plus www.stiebel-eltron.com
16.7 Energy consumption data
Product datasheet: Conventional water heaters to regulation (EU) no. 812/2013 | 814/2013
DCE-S 6/8 Plus DCE-S 10/12 Plus
238153 238154
Manufacturer STIEBEL ELTRON STIEBEL ELTRON
Load profile XS XS
Energy efficiency class A A
Energy conversion efficiency % 39 39
Annual power consumption kWh 472 474
Default temperature setting °C 60 60
Sound power level dB(A) 15 15
Special information on measuring efficiency Measured with integral flow limiter,
maximum output and maximum set value
Measured with integral flow limiter,
maximum output and maximum set value
Daily power consumption kWh 2.161 2.174
16.8 Data table
DCE-S 6/8 Plus DCE-S 10/12 Plus
238153 238154
Electrical data
Rated voltage V 220 230 240 220 230 240
Rated output kW 6.0/8.0 6.6/8.7 7.2/9.6 10.0/12.0 11.0/13.1 12.0/14.3
Rated current A 27.3/36.4 28.5/38.0 30.0/40.0 45.5/54.5 47.8/57.0 50.0/59.6
Fuse protection A 30/40 50/60
Frequency Hz 50/60 50/60
Phases 1/N/PE 1/N/PE
Resistivity ρ15 ≥ Ω cm 1100 1100
Conductivity 15 ≤ μS/cm 910 910
Max. mains impedance at 50Hz Ω 0.0385 0.0368 0.0353 0.0257 0.0245 0.0235
Connections
Water connection G 1/2 A G 1/2 A
Application limits
Minimum supply pressure MPa 0.18 (1.8 bar / 26 psi) 0.18 (1.8 bar / 26 psi)
Max. permissible pressure MPa 1 (10 bar / 150 psi) 1 (10 bar / 150 psi)
Max. inlet temperature for reheating °C 55 55
Temperature setting range °C 20-60 20-60
Values
Max. inlet temperature (e.g. pasteurisation) °C 70 70
On l/min 1.3 1.3
Flow rate at 28K l/min 3.1/4.1 @ 220V 5.1/6.2 @ 220V
Flow rate at 50K l/min 1.7/2.3 @ 220V 2.9/3.5 @ 220V
Pressure drop for flow rate at 50K (without flow limiter) MPa 0.01/0.01 0.02/0.03
Flow rate limit at l/min 4 5
Hydraulic data
Nominal capacity l 0.277 0.277
Versions
Type of installation Oversink/ undersink Oversink/ undersink
Adjustable connected load X X
Protection class 1 1
Insulating block Plastic Plastic
Heating system heat generator Bare wire Bare wire
Cover and back panel Plastic Plastic
Colour White White
IP rating IP25 IP25
Dimensions
Height mm 372 372
Width mm 217 217
Depth mm 109 109
Weights
Weight kg 2.5 2.5
Note
The appliance conforms to IEC 61000-3-12.