STIEBEL ELTRON DCE-S 6/8 Plus - Commissioning; Internal Anti-Scalding Protection via Jumper Slot; Changing the Connected Load via the Jumper Slot; Initial Start-up

INSTALLATION
Commissioning
ENGLISH
www.stiebel-eltron.com DCE-S Plus | 9
10. Commissioning
10.1 Internal anti-scalding protection via jumper
slot
43°C | 109°F
50°C | 122°F
55°C | 131°F
60°C | 140°F
D0000073624
f Install the jumper in the required position on the "Tmax" pin
strip.
Jumper position Description
43°C | 109°F Forexample in nurseries, hospitals, etc.
50°C | 122°F
55°C | 131°F Max. for shower operation
60°C | 140°F Factory setting
No jumper Limit 43°C | 109°F
CAUTION Burns
If operating with preheated water, e.g. if using a solar
thermal system, the internal anti-scalding protection can
be overridden.
f In this case, limit the temperature with an upstream
central thermostatic valve.
10.2 Changing the connected load via the jumper
slot
If you select a connected load other than the factory setting for
the appliance, you will need to reposition the jumper.
1
2
D0000082938
f Install the jumper in the required position on the "Pmax" pin
strip.
Jumper position Connected load
DCE-S 6/8 Plus DCE-S 10/12 Plus
1 [low] @ 220V 6.0kW 10.0kW
@ 230V 6.6kW 11.0kW
@ 240V 7.2kW 12.0kW
2 [high]
@ 220V 8.0kW 12.0kW
Factory setting
@ 230V 8.7kW 13.1kW
@ 240V 9.6kW 14.3kW
No jumper [low]
@ 220V 6.0kW 10.0kW
@ 230V 6.6kW 11.0kW
@ 240V 7.2kW 12.0kW
10.3 Initial start-up
f Tick the selected connected load on the type plate. Use a
ballpoint pen to do this.
≥ 3 min.
on
15 x
off
D0000101520
f Open and close all connected draw-off valves 15 times
over a period of at least 3 minutes, until all air has been
purged from the pipework and the appliance. Vent the cold
water inlet line and the appliance using a flow rate of least
3.5l/min.
f Carry out a tightness check.
D0000073622
f Activate the safety switch by firmly pressing the reset button
(the appliance is delivered with the safety switch disabled).
D0000082937
f Insert the plug of the programming unit connecting cable at
the PCB.
Note
It is essential to plug the connecting cable for the pro-
gramming unit into the PCB before switching on the
power. Otherwise, the programming unit will not func-
tion.