EasyManua.ls Logo

STIEBEL ELTRON DCE-C 6/8 Trend - 16.7 Energy Consumption Data; 16.8 Data Table

STIEBEL ELTRON DCE-C 6/8 Trend
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INSTALLATION

14 | DCE-C Trend www.stiebel-eltron.com
16.7 Energy consumption data
Product datasheet: Conventional water heaters to regulation (EU) no. 812/2013 | 814/2013
 
238148 238149
Manufacturer STIEBEL ELTRON STIEBEL ELTRON
Load profile XS XS
Energy efficiency class A A
Energy conversion efficiency % 39 39
Annual power consumption kWh 472 472
Default temperature setting °C 55 55
Sound power level dB(A) 15 15
Special information on measuring efficiency
Measured with integral flow limiter,
maximum output and maximum set
value
Measured with integral flow limiter,
maximum output and maximum set
value
Daily power consumption kWh 2.161 2.163
16.8 Data table
 
238148 238149
Electrical data
Rated voltage V 220 230 220 230
Rated output kW 6.0/8.0 6.6/8.7 10.0/12.0 11.0/13.1
Rated current A 27.3/36.4 28.5/38.0 45.5/54.5 47.8/57.0
Fuse protection A 30/40 30/40 50/60 50/60
Frequency Hz 50/60 50/60 50/60 50/60
Phases 1/N/PE 1/N/PE
Resistivity ρ15 ≥ Ω cm 1100 1100
Conductivity σ15 ≤ μS/cm 910 910
Max. mains impedance at 50Hz Ω 0.0385 0.0368 0.0257 0.0294
Connections
Water connection G 1/2 A G 1/2 A
Application limits
Max. permissible pressure MPa 1 1
Max. inlet temperature for reheating °C 55 55
Temperature setting range °C 55 55
Values
Max. inlet temperature (e.g. pasteurisation) °C 70 70
On l/min 1.3 1.3
Flow rate at 28K l/min 3.1/4.1 @ 220V 5.1/6.2 @ 220V
Flow rate at 50K l/min 1.7/2.3 @ 220V 2.9/3.5 @ 220V
Pressure drop for flow rate at 50K (without flow limiter) MPa 0.007/0.009 0.02/0.026
Flow rate limit at l/min 4 5
Hydraulic data
Nominal capacity l 0.277 0.277
Versions
Type of installation Oversink/ undersink Oversink/ undersink
Adjustable connected load X X
Protection class 1 1
Insulating block Plastic Plastic
Heating system heat generator Bare wire Bare wire
Cover and back panel Plastic Plastic
Colour White White
IP rating IP25 IP25
Dimensions
Height mm 372 372
Width mm 217 217
Depth mm 98 98
Weights
Weight kg 2.50 2.50
Note
The appliance conforms to IEC 61000-3-12.

Table of Contents

Related product manuals