INSTALLATION
Alternative installation methods
10 | DCE-C Trend www.stiebel-eltron.com
12.5 Water installation on unfinished walls
You will need the appropriate accessories to carry out the in-
stallation. The installation kit for water installation on unfinished
walls contains:
- 2 x grommets to seal the apertures in the appliance back
panel.
- Strainer with sealed edge for installation on the 45°twin
connector.
- Flat gasket
In addition, you will need the flow limiter included in the appliance
standard delivery.
Preparation
D0000073660
Insert and seal the 45°twin connectors.
To break out the apertures in the appliance back panel, you will
need to remove the function module from the back panel.
1.
4.
5.
2.
3.
D0000077971
Undo the screw and disengage the locking tab.
Push the function module on the back panel gently
backwards.
Remove the function module from the appliance back panel
by pulling it slightly forwards and lifting it out.
Push/break out the required apertures for the water connec-
tions in the back panel from behind (for positions, see chap-
ter "Specification/ Dimensions and connections"). Deburr any
sharp edges with a file.
1.
2.
3.
4.
D0000077974
1 2 3
4
5
1 Flow limiter
2 O-ring
3 Cold water pipe bend with recess for spring clip
4 Spring clip
5 Heater
Remove the cold water pipe bend and the O-ring.
Insert the flow limiter (part of the appliance standard
delivery) in the cold water inlet of the heater. Note the
orientation.
Fit the cold water pipe bend with the O-ring.
!
Material losses
The O-ring must be fitted to prevent the appliance from
leaking.
As part of installation, check that the O-ring is in
place.
Secure the cold water pipe bend with the spring clip.
!
Material losses
Ensure that the spring clip is located behind the recess
in the pipe bend and that it is securely holding the pipe
bend in place.
Fit the function module in reverse order onto the appliance
back panel until it clicks into place.
Secure the function module with the screw.
To Next Page
Loading...
