ENGLISH
77
The router switched itself off during WLAN
setup (timeout).
Repeat WLAN setup.
The WLAN reception is too weak. Check that your WLAN availability is stable at the installation location. Use
a repeater to improve signal strength if necessary.
Network connection could not be estab-
lished.
Check your access credentials. Establish a new connection from the pro-
gramming unit to the router if necessary.
When setting up WLAN access, incorrect ac-
cess credentials were entered.
Check the access credentials.
Your router does not allow connections,
forexample due to an enabled MAC filter.
Check your router configuration. Contact the router manufacturer if nec-
essary.
The stream is interrupted for a few sec-
onds or completely.
The range of the Bluetooth
®
connection is
too small.
Bring the Bluetooth
®
loudspeaker closer to the instantaneous water heat-
er.
The WLAN reception is too weak. Check the strength of the WLAN reception. Use a repeater to improve sig-
nal strength if necessary.
Note
For further problems, affecting the programming unit in
particular, contact the STIEBELELTRON SERVICE HOTLINE:
Tel. 0 55 31 - 702 702
Note
After a power failure
The programming unit displays and the selected settings
are retained following a power failure.
If you cannot remedy the fault, contact your qualified contractor.
To facilitate and speed up your enquiry, please provide the serial
number from the type plate (000000-0000-000000) or scan the
QR code.
DHE....
Nr. 000000-0000-00000
DHE....
Nr. 000000-0000-00000
D0000053312
Mini wireless remote control battery replacement
To Next Page
Loading...
