STIEBEL ELTRON DHM 6 220 - Tap Installation Guidelines; Oversink Tap Installation

ENGLISH
www.stiebel-eltron.com DHM 6 220 | 11
INSTALLATION
INSTALLATION
 Route the power cable through the cable entry in the back
panel.
 Hook in the appliance cover with the heater at the bottom.
 Click the heater into place using the snap fastener.
 Secure the appliance cover with the cover fixing screws.
10.2.2 Tap installation
!
Material losses
When making the connections, counter the torque on the
appliance using a size 14 spanner.
 Fit the 3/8 connection hose provided and the 3/8 tee.
 Install the tap. For this, also observe the tap operating and
installation instructions.
10.2.3 Oversink installation, non-pressurised, with non-
pressurised tap
26_02_05_0081_
Tap installation
 Fit the tap according to the illustration. For this, also observe
the tap operating and installation instructions.
!
Material losses
When making the connections, counter the torque on the
appliance using a size 14 spanner; see chapter "Installa-
tion alternatives/ Undersink installation".