STIEBEL ELTRON DHM 6 220 - Appliance Description and Standard Delivery; Installation Standards and Regulations; Optional Accessories; Installation Preparations

INSTALLATION
APPLIANCE DESCRIPTION
8 | DHM 6 220 www.stiebel-eltron.com
7.2 Instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
The specific electrical resistance of the water must not fall below
that stated on the type plate. In a linked water network, factor in
the lowest electrical resistance of the water (see chapter “Speci-
fication/ Data table”). Your water supply utility will advise you of
the specific electrical water resistance or conductivity.
8. Appliance description
8.1 Standard delivery
The following are delivered with the appliance:
- Sieve inside the cold water inlet
- Special aerator “SR”
- Connection hose 3/8, 500mm long, with gaskets*
- Tee 3/8*
- Company logo for oversink installation
*for the connection as pressure-tested appliance
8.2 Accessories
Special aerator “SR”*
- SR 5: Part number 270582
* For use in thread M22/M24.
Pressure-tested tap
- WEH Sensor tap for washbasins
ZTA 3/4 - central thermostatic valve
Thermostatic valve for central premixing, for example for operat-
ing an instantaneous water heater with a solar thermal system.
9. Preparations
 Flush the water line thoroughly.
Water installation
A safety valve is not required.
Taps
 Use suitable taps (see chapter “Appliance description/
Accessories”).