20 |
11.5 Closing the terminal area
D0000035356
1
2
1 Serrated washer
2 Screw
Secure the cover with the screw and serrated washer.
Connect the following components to the heat pump manag-
er in accordance with the technical guides:
- Circulation pump for the heat consumer side
- Outside temperature sensor
- Return sensor (only for operation with buffer cylinder)
11.6 Ribbon heater
A ribbon heater (see chapter "Installation/ Appliance description/
Accessories/ Further accessories") can be fitted to the condensate
pan and the condensate hose.
Install a ribbon heater when mounting on the wall bracket or
T-support.
When installing on foundations or the mounting bracket, we rec-
ommend installing a ribbon heater if the routing of the condensate
hose means it is at risk of frost or is fully exposed to the elements.
Access to the terminal area
26_03_01_1544
Remove the cover.
A.
1
D0000035975
1 Electrical connection for ribbon heater
Guide the ribbon heater through the appliance.
D0000033168
Guide the ribbon heater into the condensate drain pipe.
B.
D0000035976
Make the electrical connection for the ribbon heater.
Power supply: L, N, PE
To Next Page
Loading...
