Repair instructions
HPG-I 04-06-08-12-15 S-CS-DS-DCS
Premium
• If several circuits are required for cooling, this is only possible with FETs. The
cooling tank is passively cooled to the lowest setpoint temperature.
• Summer mode must be activated. The control unit must be in automatic mode.
6. Device description
6.1
Housing
The enclosure concept consists of a frame with a closed rear wall and recessed grips for transport. The
symmetrical side panels are hooked into hinges of the frame. The front wall is attached in the upper area
via sliding hooks. The hooks are secured with screws. The top cover is designed to slide and allows easy
electrical connection after removal of the rear top cover strip. The enclosure is tightly sealed by a built-in
fan with pressure monitoring. A test port is located on the rear wall of the unit.
7. Circuit diagram
To Next Page
Loading...
