STIEBEL ELTRON SOM 8 PLUS - Basic Systems and Hydraulic Variants

12
5 Initial commissioning
When the hydraulic system is lled and ready for
operation, connect the controller to the mains.
The controller runs an initialisation phase in which
the directional pad ashes red.
When the controller is commissioned for the rst
time or when it is reset, it will run a commissioning
menu after the initialisation phase. The commissio-
ning menu leads the user through the most impor-
tant adjustment channels needed for operating the
system.
Commissioning menu
The commissioning menu consists of the channels
described in the following. In order to make an ad-
justment, push button
5
. Adjust the value by pres-
sing buttons
4
and
2
, then bush button
5
to
conrm. The next channel will appear on the display.
5
5
adjustment mode
button navigation
changing a value
conrming a value
next parameter appears auto-
matically
2
4
1. Language:
Î Adjust the desired menu language.
2. Units:
Î Adjust the desired temperature unit.
Î Adjust the desired volume unit.
Î Adjust the desired pressure unit.
Î Adjust the desired energy unit.
295931-36390-8667 SOM 8 plus_en.indb 12 20.10.2011 13:14:25