71
14 Manual mode
In the Manual mode menu, the operating mode of
all relays in the controller and in connected modules
can be adjusted.
All relays are displayed in numerical order, rst those
of the controller, then those of the individual modu-
les connected. Modules are listed in numerical order.
Under the menu item All relays..., all relays can be
switched o (O) or set to automatic mode (Auto)
at once.
O = Relay is switched o (manual mode)
Auto = Relay is in automatic mode
The operating mode can be selected for each indivi-
dual relay, too. The following options are available:
O = Relay is switched o (manual mode)
Min. = Relay active with minimum speed
(manual mode)
Max. = Relay active at 100 % speed (manual
mode)
Auto = Relay is in automatic mode
Note:
Always adjust the operating mode back to
Auto when the control and service work is
completed. Otherwise normal operation
will not be possible.
Adjustment channel Description Adjustment range / selection Factory setting
Relays R1 ... X Operating mode selection Max, Auto, Min, O Auto
All relays... Operating mode selection for all
relays
Auto, O O
Manual mode
295931-36390-8667 SOM 8 plus_en.indb 71 20.10.2011 13:14:57
To Next Page
Loading...