70
Starting the logging
Î Insert the SD card into the slot
Î Adjust the desired logging type and interval
Logging will start immediately.
Stop the logging
Î Select the menu item Remove card...
Î After Remove card is displayed, remove the
card from the slot
When Linear is adjusted in the adjustment channel
Logging type, data logging will stop if the capacity
limit is reached. The message Card full will be dis-
played.
If Cyclic is adjusted, the oldest data logged onto the
SD card will be overwritten as soon as the capacity
limit is reached.
Note:
Because of the increasing size of the data
packets, the remaining logging time does
not decrease linearly. The data packet size
can increase, e. g. with the increasing ope-
rating hours value.
Note:
To safely remove the SD card, always select
the menu item Remove card... before re-
moving the card.
Storing controller adjustments
Î To store the controller adjustments on an SD
card, select the menu item Save adjustments.
While the adjustments are being stored, rst Please
wait, then Done! will be indicated on the display.
The controller adjustments are stored as a .SET le
on the SD card.
Loading controller adjustments
Î To load controller adjustments from an SD card,
select the menu item Load adjustments.
The File selection window is indicated.
Î Select the desired .SET le.
While the adjustments are being loaded, rst Please
wait, then Done! will be indicated on the display.
Formatting the SD card
Î Select the menu item Format card
The content of the card will be deleted and the card
will be formatted with the FAT le system.
Adjustment channel Description Adjustment range / selection Factory setting
Remove card... Safely remove card - -
Save adjustments Save adjustments - -
Load adjustments Load adjustments - -
Logging interval Logging interval 00:01 ... 20:00 (mm:ss) 01:00
Logging type Logging type Cyclic, Linear Linear
Format card Format card - -
SD card
295931-36390-8667 SOM 8 plus_en.indb 70 20.10.2011 13:14:56
To Next Page
Loading...