www.stiebel-eltron.com UFP 5 h | 15
ENGLISH
INSTALLATION
Safety
INSTALLATION
6. Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
6.1 General safety instructions
We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
6.2 Instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
7. Appliance description
The open vented (non-pressurised) appliance is suitable only for
oversink installation. The appliance is intended to heat cold water
and supply it to a single draw-off point.
The appliance must only be installed with an open (non-pres-
surised) tap.
7.1 Standard delivery
Delivered with the appliance are the following:
- Wall mounting bracket
7.2 Required accessories
Select an open (non-pressurised) tap that is appropriate for your
requirements and equipment:
Twin-handle mixer tap
- WKM
Mono lever mixer tap
- MEK
8. Preparations
Flush the water line thoroughly.
Water installation
A safety valve is not required.
Taps/valves
Sealed unvented taps are not permitted.
Install an open vented tap.
8.1 Installation site
!
Material losses
Install the appliance in a room free from the risk of frost.
!
Material losses
Mount the appliance on the wall. The wall must have a
sufficient load-bearing capacity.
!
Material losses
Connecting hose length (from tap to appliance) may not
exceed 1 m.
For connecting hoses >1m:
Install a tube aerator attachment in the overflow
line.
Note
The appliance is only suitable for oversink installation.
The water connections of the appliance point downwards.
Note
Ensure that the appliance is freely accessible for main-
tenance work.
Always install the appliance vertically and near the draw-off point.
850 200-300
D0000049906
9. Installation
9.1 Appliance installation
Mark out the holes to be drilled on the wall (see chapter "In-
stallation/ Specification/ Dimensions and connections").
Drill the holes and insert suitable rawl plugs.
Secure the wall mounting bracket using suitable screws.
Hang the appliance on the wall mounting bracket.
Note
Surplus cable can be stored in the cable compartment.
To Next Page
Loading...
