EasyManua.ls Logo

STIEBEL ELTRON WPL 09 ICS classic - Default Chapter; Table of Contents

STIEBEL ELTRON WPL 09 ICS classic
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2 |WPL ICS classic | WPL IKCS classic www.stiebel-eltron.com
CONTENTS
SPECIAL INFORMATION
OPERATION
1. General information �����������������������������������������3
1.1 Relevant documents_____________________________________________ 3
1.2 Safety instructions _______________________________________________ 3
1.3 Other symbols in this documentation _______________________ 4
1.4 Units of measurement __________________________________________ 4
1.5 Standardised output data ______________________________________ 4
2. Safety ���������������������������������������������������������� 4
2.1 Intended use ______________________________________________________ 4
2.2 Safety instructions _______________________________________________ 4
2.3 Test symbols ______________________________________________________ 4
3. Appliance description ���������������������������������������5
3.1 Function ___________________________________________________________ 5
4. Settings �������������������������������������������������������5
5. Maintenance and care ���������������������������������������5
6. Troubleshooting ����������������������������������������������6
INSTALLATION
7. Safety ���������������������������������������������������������� 7
7.1 General safety instructions ____________________________________ 7
7.2 Instructions, standards and regulations ____________________ 7
7.3 Operation of the appliance in buildings with
combustion equipment _________________________________________ 7
8. Appliance description ���������������������������������������7
8.1 Standard delivery ________________________________________________ 7
8.2 Required accessories ___________________________________________ 7
8.3 Additional accessories __________________________________________ 7
9. Preparation ���������������������������������������������������7
9.1 Sound emissions _________________________________________________ 7
9.2 Minimum clearances ____________________________________________ 8
9.3 Preparing the installation location ___________________________ 9
9.4 Wall outlet _________________________________________________________ 9
9.5 Preparing the electrical installation ________________________ 11
9.6 Buffer cylinder __________________________________________________ 12
10. Installation �������������������������������������������������� 12
10.1 Transport _________________________________________________________ 12
10.2 Siting ______________________________________________________________ 13
10.3 Flow and return connection __________________________________ 13
10.4 Fitting the push-fit connectors _______________________________13
10.5 Heating water connection _____________________________________ 14
10.6 Oxygen diffusion ________________________________________________ 14
10.7 Second heat generator ________________________________________ 14
10.8 Condensate drain and overpressure valve _________________ 15
10.9 Checking the condensate drain ______________________________ 15
10.10 Temperature controller for underoor heating systems 15
10.11 Filling the heating system ____________________________________ 15
10.12 Venting the heating system ___________________________________ 16
10.13 Minimum flow rate _____________________________________________ 16
10.14 Flow rate on the heating side ________________________________ 16
11. Electrical connection ��������������������������������������� 17
11.1 Terminal area ____________________________________________________ 17
12. Fitting the appliance casing ������������������������������� 19
12.1 Fitting the cover panels _______________________________________ 19
12.2 Fitting the side panels _________________________________________ 20
12.3 Fitting the front panel _________________________________________20
13. Routing the air hoses �������������������������������������� 21
13.1 Connection with air routing accessory
LSWP315AWGSet _____________________________________________ 21
13.2 Connection with quick-fit adaptor ZSA315 ________________ 22
14. Commissioning ��������������������������������������������� 22
14.1 Checks to be carried out before commissioning the
heat pump manager ___________________________________________ 22
14.2 Commissioning the heat pump manager __________________ 22
14.3 Initial start-up ___________________________________________________ 22
15. Appliance shutdown ��������������������������������������� 23
15.1 Standby mode ___________________________________________________ 23
15.2 Power interruption _____________________________________________ 23
16. Appliance handover ���������������������������������������� 23
17. Troubleshooting �������������������������������������������� 23
17.1 Control elements on the IWS _________________________________ 24
17.2 Resetting the temperature controller _______________________ 25
17.3 Fan noise _________________________________________________________ 25
18. Maintenance ������������������������������������������������ 25
18.1 Cleaning the evaporator fins _________________________________ 25
18.2 Cleaning the condensate drain _______________________________26
19. Specification ������������������������������������������������ 28
19.1 Dimensions and connections _________________________________ 28
19.2 Wiring diagram _________________________________________________ 30
19.3 Output diagrams ________________________________________________ 33
19.4 Data table ________________________________________________________ 39
GUARANTEE
ENVIRONMENT AND RECYCLING

Table of Contents

Related product manuals