EasyManuals Logo

STIEBEL ELTRON WPL 15 AS User Manual

STIEBEL ELTRON WPL 15 AS
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
2  www.stiebel-eltron.com

SPECIAL INFORMATION
OPERATION
1. General information �����������������������������������������3
1.1 Relevant documents_____________________________________________ 3
1.2 Safety instructions _______________________________________________ 3
1.3 Other symbols in this documentation _______________________ 4
1.4 Units of measurement __________________________________________ 4
1.5 Standardised output data ______________________________________ 4
2. Safety ���������������������������������������������������������� 4
2.1 Intended use ______________________________________________________ 4
2.2 Safety instructions _______________________________________________ 4
3. Appliance description ���������������������������������������5
3.1 Properties _________________________________________________________ 5
3.2 Function ___________________________________________________________ 5
4. Settings ������������������������������������������������������� 5
5. Maintenance and care ���������������������������������������6
6. Troubleshooting ����������������������������������������������6
INSTALLATION
7. Safety ���������������������������������������������������������� 7
7.1 General safety instructions ____________________________________ 7
7.2 Instructions, standards and regulations ____________________ 7
8. Appliance description ���������������������������������������7
8.1 Accessories ________________________________________________________ 7
9. Preparation ���������������������������������������������������7
9.1 Sound emissions _________________________________________________ 7
9.2 Minimum clearances ____________________________________________ 8
9.3 Preparing the installation location ___________________________ 8
9.4 Installing the supply lines ______________________________________ 8
9.5 Siting _______________________________________________________________ 8
9.6 WPM heat pump manager ____________________________________ 11
9.7 Buffer cylinder __________________________________________________ 11
9.8 Preparing the electrical installation ________________________ 11
10. Installation �������������������������������������������������� 12
10.1 Transport _________________________________________________________ 12
10.2 Heating water connection _____________________________________ 12
10.3 Flow and return connection __________________________________ 12
10.4 Fitting the push-fit connectors _______________________________ 12
10.5 Oxygen diffusion ________________________________________________ 13
10.6 Filling the heating system ____________________________________ 13
10.7 Minimum flow rate _____________________________________________ 14
10.8 Setting the flow rate on the heating side __________________ 14
10.9 Condensate drain _______________________________________________ 15
10.10 External second heat generator _____________________________ 16
10.11 High limit safety cut-out for underoor heating
systems ___________________________________________________________16
11. Electrical connection ��������������������������������������� 16
11.1 Access to the terminal area ___________________________________16
11.2 WPL 15 AS | WPL15ACS _______________________________________ 18
11.3 WPL20A | WPL20AC | WPL25A | WPL25AC ____________ 18
11.4 WPL25AS | WPL25ACS _______________________________________ 19
11.5 Closing the terminal area _____________________________________ 19
11.6 Ribbon heater ___________________________________________________ 19
12. Commissioning ��������������������������������������������� 20
12.1 Checks before commissioning________________________________ 20
12.2 Using the appliance with an external second heat
generator _________________________________________________________ 21
12.3 Initial start-up ___________________________________________________ 21
12.4 Appliance handover ____________________________________________ 22
13. Settings ����������������������������������������������������� 22
13.1 Silent mode ______________________________________________________ 22
14. Appliance shutdown ��������������������������������������� 22
14.1 Standby mode ___________________________________________________ 22
14.2 Power interruption _____________________________________________ 22
15. Maintenance ������������������������������������������������ 22
16. Troubleshooting �������������������������������������������� 23
16.1 Checking the IWS DIP switch settings ______________________ 23
16.2 Light emitting diodes (LEDs) __________________________________ 25
16.3 Reset button _____________________________________________________ 25
16.4 Resetting the high limit safety cut-out _____________________ 25
16.5 Fan noise _________________________________________________________ 25
17. Specification ������������������������������������������������ 27
17.1 Dimensions and connections _________________________________ 27
17.2 Wiring diagram _________________________________________________ 30
17.3 Application limit ________________________________________________ 34
17.4 Output diagrams ________________________________________________ 35
17.5 Data table ________________________________________________________ 41
GUARANTEE
ENVIRONMENT AND RECYCLING

Table of Contents

Other manuals for STIEBEL ELTRON WPL 15 AS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the STIEBEL ELTRON WPL 15 AS and is the answer not in the manual?

STIEBEL ELTRON WPL 15 AS Specifications

General IconGeneral
BrandSTIEBEL ELTRON
ModelWPL 15 AS
CategoryHeat Pump
LanguageEnglish

Related product manuals