Stiga Autoclip M7 User Manual

28
User’s manual
EN
1. Press the ON key and wait a few seconds for the robot to turn on completely.
Enter the password (if prompted) (See “Password Entry”). Press “Enter” if the
information messages remain on the display.
2. The “PAUSE” function appears on the display.
ON
ENTER
PAUSE
3. Enter into programming mode and select “WORK MODE”. Select “CLOSED
AREA” and the words “CLOSED AREA – 60 Min” (default value) will appear
on the display.
4. Press either the “+” or “-” key to set the minutes.
5. Press “ENTER” to conrm.
6. Press the “PLAY/PAUSE” key to exit the programming menu and then restart
the robot. After the set time, the robot safely stops next to the perimeter wire.
7. Restore the normal functioning of the robot as described in chapter “INITIAL
START UP – AUTOMATIC MODE”.
ON
ENTER
CLOSED AREA
60 min
PASSWORD ENTRY
The robot can be protected by a password consisting of four numbers which can be enabled, disabled and personalised by the
user (see “Programming Mode”).
1. On the display appears the message:
2. Press either the “+” or “-” key to set the rst number.
3. Press “ENTER” to conrm. The cursor moves to the next position.
4. Repeat the procedure to set all the numbers of the password.
The robot is now ready for use.
ON
ENTER
PASSWORD
0000
VISUALISING THE DISPLAY DURING THE WORK PHASE
While in operation, the following data appears on the display of the robot:
-
speed of mower;
-
cutting blade speed;
-
percentage of battery charge.
While the robot is charging, the word “CHARGING” appears on the display.
If the robot is outside the working time, the display shows the day and time of the
next scheduled start.
ON
ENTER
28m/min 2800rpm
Battery 75%

Stiga Autoclip M7 Specifications

General

Brand	Stiga
Model	Autoclip M7
Category	Lawn Mower
Language	English