EN - 7
4.2.3
1.
2.
sure that the controls are on the right.
3.
4.
4.3 CHOOSING CUTTING MEANS
AND SPECIFIC GUARD
Every cutting means must
be tted with a specic guard, as
indicated by the following directions
in the Technical Data table.
job to be done, according to these general indi-
• the cutting line head
• the 3-point blade is suitable
•
IMPORTANT When the cutting
means has to be changed, dismantle
all the elements of the device.
4.4 FITTING CUTTING MEANS GUARD
Wear protective gloves.
4.4.1 Fitting the guard on the
IMPORTANT Whenever you use
this protection, make sure that the
plate of the transmission tube (Fig.
6.B, Fig. 6.E) is assembled.
1.
2.
3.
NOTE On the guard of the cutting means
(Fig. 1.E) there is the following symbol:
Indicates the rotation direction
4.4.2 Fitting the guard on the cutting
This guard must not be used
for other cutting devices.
1.
been used for other cutting devices.
2.
3.
4.
5. on
the holes of the support.
6. Fix the guard
4.5
Wear protective gloves.
4.5.1 Fitting cutting line head
1.
1.a Type I: W
1.b Type II: Wi
To Next Page
Loading...
