EN - 20
8.4 ELECTRONIC CIRCUIT BOARD
8.4.1 Electronic circuit board
(for rear
collection models only)
• The electronic circuit board is located
circuit if there is a fault or short circuit
8.4.2 Electronic circuit board protection
fuse (for side discharge models only)
•
8.5
circuits of the electronic circuit board.
for rear
discharge models only (par. 5.11)
IMPORTANT A blown fuse must always be
replaced by one of the same type and ampere
rating, and never with one of another rating.
8.6 REPLACING BULBS
8.6.1 Type "l" - Incandescent light bulbs
•
and are installed in the bulb holder
8.6.2 Type "ll" - LED light bulbs
•
8.7 REAR AXLE
• This is a sealed single unit that does not
lubricated and its lubricant does not
need changing or topping up.
9. STORING THE MACHINE
1. Wait for the engine to cool
2.
3.
4.
5.
authorised assistance centre.
6.
possible (par. 15.4)
•
•
To Next Page
Loading...
