EN - 24
PROBLEM PROBABLE CAUSE
4.
«START» the starter
(for side discharge
models only)
(par. 6.2.2)
replace fuse (10 A) (par. 8.5).
5.
«START» the starter
engine does not start
foreseen) (par. 6.4)
and have the correct gap
6.
7.
during cutting
relation to cutting height
raise the cutting height (par. 6.5.4)
8. The engine shuts
(for
side discharge models only)
The cause of the fault should be
reactivating the protection device
Replace the fuse (10 A) (par. 8.5).
interruptions continue
operating and the
(for rear collection
models only)
circuit board has cut in due to:
short circuit
10.
not engage or do not
To Next Page
Loading...
Need help?
General
