Stiga Stig 300 - Installation of the Perimeter Cable

24 EN
4. INSTALLATION
4.5.1. 






• Low grass all the way • Hammer
• Perimeter cable • 
• Fixing pegs • 
• Joints for perimeter cable • Electrician's scissors
• Pliers







1. Place the perimeter cable (A) starting from the charging base installation area.
2. 
100 cm apart, and observing the installation requirements (see Par. 4.3 and Par. 4.4).
3. 
NOTE: In non-straight sections, make sure that the cable (A) does not get tangled. Position the
cable in such a way as to form a regular curve with a radius of about 20 cm
NOTE: The perimeter cable used for installation must be at least 40 m. long. If the cable is
shorter, it will be necessary to install the resistor for small perimeters. (See Par. 4.5.4. and Chap.
9 “Accessories”).



R=20 cm
A
100 cm
B