EN - 8
•
Action Result
1. gear in “neutral”;
2. cutting means disengaged;
operator seated.
the operator leaves his seat
or the rear discharge guard
removed without disengaging
the cutting means.
engaged without disengaging
the cutting means
speed change is
activated or the drive
pedal with the parking
brake engaged
with the cutting means
engaged, without pressing
the consent button (par. 4)
5.3. USING ON SLOPES
IMPORTANT Only for models with mechanical drive: Never
drive downhill with the gear in neutral or the clutch disengaged!
Always engage a low gear before leaving the machine station-
ary and unattended.
5.4. STARTING AND OPERATION
• Start-up
1.
2. Sit in the operator’s position.
Put the drive in neutral (“N”).
4. Disengage the cutting means.
5. Engage the parking brake.
6.
“hare”.
7.
8.
circuit. Wait 2 seconds and turn it to the start-up position
to start the engine.
9.
10. Deactivate the choke command setting the accelerator
command to the maximum speed - “hare”.
11. Disengage the choke command.
NOTE Using the choke when the engine is already warm can
foul the spark plugs and cause the engine to run erratically.
12.
the minimum “tortoise” speed position.
NOTE If there are engine starting problems, do not persist
as you can risk running the battery flat and flooding the engine.
Turn the key to the Off position, wait for a few seconds and then
repeat the operation. If the malfunction persists, refer to the en-
gine owner's manual and chapter 8 in this manual.
• Forward gear and riding without mowing
1. Disengage the cutting means.
2.
“tortoise” and “hare” speed positions.
4.
5. -
pedal and operating the throttle.
Traction must be engaged in the manner
lose control.
• Braking
•
IMPORTANT Reverse must be engaged when the machine
has stopped.
1. Press the pedal until the machine comes to a stop.
2.
direction.
• Grass cutting
1.
2.
-
4.
as described above;
5.
Disengage the cutting means and move the cutting means
• When moving between work areas
•
•
To Next Page
Loading...
Need help?
General
