EN - 10
1.
2.
and start the machine.
4.
means.
5.
machine.
6.
the coupling.
7. Repeat the procedure on the other coupling.
8.
6.4. BATTERY
as soon as possible.
IMPORTANT Recharging must be done using a battery
charger at constant voltage. Other recharging systems can irre-
versibly damage the battery.
29
IMPORTANT This connector must only be used for con-
nection to the maintenance battery charger indicated by the
Manufacturer. For its use:
- follow the instructions given in the relative instruction manual;
- follow the instructions in the battery manual.
6.5. CUTTING MEANS MAINTENANCE
Do not touch the cutting means until the ignition
completely stationary. Be careful that the cutting
All work on the cutting means (disassembly,
sharpening, balancing, repairing, reassembly
special skills as well as special tools; For safety
Always replace damaged, bent or worn cutting
means, together with their nuts and bolts, in order
to ensure they remain balanced.
IMPORTANT Always use original cutting means bearing the
code indicated in the “Technical Data” table.
7. TRANSPORT, STORAGE AND
DISPOSAL
7.1. TRANSPORT
1. disengage the cutting means;
2.
4. disengage the drive (par.4).
•
•
•
•
•
• engage the drive (par.4);
•
7.2. STORAGE
•
•
•
engine manual.
•
•
the authorised service centre.
Store the machine:
•
•
•
•
•
•
removed.
•
stopcock or carburettor:
•
the machine”.
NOTE Ensure that the battery is fully charged at least once a
month and always before use.
NOTE Store the machine so as to avoid any risk in the event
of accidental contact with people, children or animals.
To Next Page
Loading...
Need help?
General
