EN - 11
8. TROUBLESHOOTING
PROBLEM PROBABLE CAUSE SOLUTION
1.
to the “ON” position,
switch on and there
is no acoustic signal
circuit board has cut in due to:
wet circuit board
2.
to the “ON” position,
the dashboard
but the acoustic
signal is activated
circuit board has cut in due to:
wet circuit board
dashboard is
illuminated, but
the starter motor
does not run
4.
motor runs but the
engine does not start
check the level in the tank (par. 6.2)
check that the electrodes are clean
and have the correct gap
5.
or the engine
carburation problems
6. Weak engine
during cutting
relation to the cutting height
raise the cutting height (par. 5.4)
7.
when the cutting
device are engaged
engage not enabled check that all starting conditions
are met (par. 5.2)
8.
light remains on even
has been running
9.
switches on during
engine lubrication problems
top-up the oil level (see 6.2)
10.
running and an
acoustic signal
is generated
circuit board has cut in due to:
the charger regulator
11.
running, and no
acoustic signal
is generated
engine problems
To Next Page
Loading...
