EN - 9
• Grass catcher emptying
IMPORTANT The grass catcher can only be emptied with the
cutting means disengaged; otherwise the engine stops.
1. disengage the cutting means;
2. reduce engine speed;
Put the drive in neutral (N)and stop the movement;
4. engage the parking brake;
1. extract the lever (Fig. 24.A) and tip the grass catcher bag
2. close the grass catcher again so that it remains coupled
to the pawl (Fig. 24.B) and replace the lever.
Electrical control:
1. with the operator seated, press and hold the button
position;
2.
make sure that it remains coupled to the pawl (Fig. 24.B).
This operation must be carried out with the
5.5. STOP
1.
minimum “tortoise” speed position for 20
2.
4.
IMPORTANT To keep the battery charged, do not leave the
ignition key in the “on” or “headlights on” position when the en-
gine is not running.
5.6. AFTER USE
•
•
the driving seat or parks the machine:
1. Stop the machine.
2.
position.
-
plete stop.
4.
6. MAINTENANCE
serious risks or hazards:
• Disengage the cutting means.
• Stop the machine.
•
• Engage the parking brake.
• Stop the engine.
•
•
• Use suitable clothing, protective gloves and goggles.
IMPORTANT Never leave the key inserted or within reach of
children or unauthorized people.
6.1. REFUELLING
1.
2.
4.
5.
IMPORTANT Consult the engine owner's manual for the type
of fuel to be used.
IMPORTANT Do not drip petrol onto the plastic parts to avoid
ruining them. In the event of accidental leaks, rinse immediately
with water. The warranty does not cover for damage to plastic
parts of the bodywork or the engine caused by petrol.
6.2.
NOTE Consult the engine owner's manual for the type of oil
to be used.
IMPORTANT Observe the precautions provided in the en-
gine owner's manual.
Check the oil level: according to the instructions in the engine
the dipstick (Fig. 26).
6.3. CLEANING
• General instructions
below:
•
• Remove grass debris and mud accumulated inside the
chassis.
•
•
•
leaves residues or excessive grease.
• Cleaning the cutting means assembly
IMPORTANT Washing the inside of the cutting means as-
sembly and the discharge chute must be performed with the
grass catcher mounted and the mulching cap inserted (if pres-
ent) or with the rear discharge guard mounted.
To Next Page
Loading...
Need help?
General
